Nutcracker Drosselmeyer designed to be printed in parts to allow separate colors without requiring an MMU. About 12.75" tall without base.
Notes:
Recommend assembling from the base up
Base without date included
Generally print parts upright as they are on the model
Parts to print with brim and supports to base:
Lever (may work better printed with Cape side down)
Beard
Cane (on it's side)
Parts to print with brim:
CaneCap
Leg (2x)
ArmUpper (2x)
ArmLower (2x)
All Toy parts
Buttons (may or may not need brim, best printed with flat back side down)
Special notes (there are some complex parts to the model, please read):
Toy parts are very small
ArmHand part included if Hand is not primtable by itself
Full toy included if parts are too small to print
Since toy parts are very small, things like eyes/eye brows/mustaches/hat chain/jewel are not printed and are colored with permanent marker/paint pen
Watch hands were too small to print, so just printed as part of the watch face and colored with permanent marker/paint pen
Insert the top of the body trim and seat completely before rotating the base under the body - it is delicate and will break off with too much force (not too much of a problem because the leg tabs go into the body and will hold the lower part in position
Lever/Beard/Cape need to be assembled together before inserting into the body
The beard is meant to slide on the outside of the body when the lever moves, make sure the beard channel is clean and it moves smoothly before continuing the rest of the assembly
Keep beard and cape parallel to each other and slide vertically into the body
The lever pins go through the cape (which is not ideal) and once pressed in, cannot be easily removed, so make sure everything is fitting and moving appropriately before pressing them in
Scaling might work, I have not tried. There are some tight tolerances, so may not work.
Scaugust
