-- OUTDATED -- Raspberry Pi Zero minimal flat case with LED indicator hole & rubber feet indents.[Remix]

THIS MODEL HAS BEEN REPLACED WITH A NEWER EDITION. THE FOLLOWING IS ONLY FOR REFERENCE PURPOSES. The update version can be found here.

This is a Remix of the amazing Raspberry Pi Zero minimal flat case by Skov Knudsen Inventions. It has a hole for the Zero's LED indicator as well as indents for rubber feet (6mm diameter). These feet are commonly used as drawer stoppers or non-slip feet on other Raspberry Pi cases. I hope you like it! :)

Here are the rubber feet I used:
https://www.amazon.com/Ehanmu-Self-Adhesive-Rubber-Bumpons-Diameter/dp/B06XCNM69B/ref=sr_1_13?dchild=1&keywords=rubber+feet&qid=1604245044&sr=8-13

Thanks to Skov Knudsen Inventions for creating this awesome case! :DD

Be sure to check out the original model here: https://www.prusaprinters.org/prints/43304-raspberry-pi-zero-minimal-flat-case

I would appreciate any feedback :)

Note: The top is un-modified, but is included here for completeness.

Print instructions

I printed this at a 0.20mm layer height in Fillamentum Royal Blue PLA and the bottom in the included Prusa PLA.