Flag mounting

You want to hang a flag on a flagpole without it getting all wrapped up? I got you!

Just attach the flag to two rings, slap a clamp about 5mm above and below each ring, and screw them onto the pole. When the wind starts blowing, the rings will spin around the pole, and your flag won't get tangled like it would with a regular setup.

These parts are made for a 42.5mm pole, but you can easily scale them up or down to fit your needs. So, wave your flag high and proud, without any nasty knots!

Printing information

Design Software: Fusion 360
Slicer: Prusa Slicer

Layer height: 0.20/0.40 mm (0.4/0.6 nozzle)
Perimeters: 3
Infill: 25%
Support: none

I am looking forward to your Makes! :-)

If you like this model, feel free to check out my others here.

And maybe you would like to support me with a small donation. Feel free to use the support button on the top right of this page. I myself donate one or two Euros to each designer for an interesting model that is worth five stars to me.

The following filament was used in the pictures above:

• Extrudr PETG black