Laundry Detergent Cup Drainer

This is a minor remix because the original did not fit my All detergent bottle.  The outside diameter measured over the bottle threads is 37.5 mm on mine.  I rounded off the sides, made the lip around the edge taller and reinforced the joint between the funnel and the pipe while I was modifying the model.

I had to print with a raft but no supports were required.  The top is pretty steep when printing but the bridges are short, and its on the inside so was not a problem.  Thanks to SteveS42 for including the Fusion 360 model which made this a quick edit.  I actually like this other design better because it seals up the bottle using the cap to reduce evaporation:

 https://www.printables.com/model/16713-laundry-detergent-cup-drain-new-tide-cup

But I printed this one and it works fine.  If I had to print it again I would make the rim fit the cup closer though.