April 18, 2023
Description
!!! Disclaimer !!!
It came to my attention that HDDs can reach temps up to 60°C (140°F) degrees.
The design has no active ventilation, that means you might damage drives due to heat, so be careful, and accept the risk if you decided to use it.
This also means that this model should be printed with PETG (or more heat-resistant plastic) to not get softened plastic in higher heat situations.
Parts needed:
Let's hope I didn't forget anything :)
Use supports on obvious places, also I was using PLA for body and PETG for drawers, however I think it does not matter for any of the part.
I am printing with 100.5% scale to compensate plastic shrinkage - the drives fit perfectly
License:
Creative Commons — Attribution — Noncommercial
MartasSan
