Braava M6 Non-slip Dock Plate

This dock plate should be a drop in replacement for the existing Braava M6 dock plate. I added more and larger ridges for the wheel grips as well as more raised bumps and channels to hopefully increase ventilation under the mopping pad.

There are two different versions, a full print for for larger printers (~300mm x ~300mm) and a split version that will fit on a 220mm plate. Supports are required for both versions as there is a raised lip on the top center section that does not reach the floor. The split version can be glued together after printing.

PLA or PETG should be fine but I would recommend sealing it as it will be in contact with a wet mop pad. Just don't use dark colors may cause the mop to think it's near a cliff.

(The photo is of an older version that I printed in black PLA, glued together with hot glue, and had to spray paint white. Not the prettiest but it works!)