Simplest LED Bar Mount for Prusa MK3/MK4

I couldn't find a simple and "minimalist" LED bar for my Prusa MK3S+, so I decided to make one of my own. It will give you enough light to see what your printer is doing without taking too much space. 

It's detachable so if for some reason you need to take it off you can remove it with ease.

You can also 3D print a diffuser if you wish to make the LED light spread better (you will need to glue it with CA glue or any other glue of your choice that will hold the heat caused by the LED).

I also made a simple guide that hold the wiring from the LED to the power supply to keep it clean and neat.

As for hardware, you will need the following:

1. 4x M3x10 hex screws.
2. 20cm (~7.8inch) of 24v LED strip (wire it to the PSU / EinsyRAMBO).
3. 8mm cable sleeve [Optional].
4. 4x M3x16 countersunk screws [Optional - to attach LED-Cable-Holder part to Prusa's frame].

Print with PETG or ABS/ASA so the models will not diform (at least LED-Strip-Holder and LED-Strip-Diffuser parts).