Dewalt Impact Driver Magnetic Bit holders

These are Bit holders that fix to the side of a Dewalt Impact Driver and probably the drills as well if they have the magnetic bit holder option.

These will hold 5 bits and require an N52 Neodymium magnet of 60mm x 10mm x5mm for the 5mm version and 60mm x 10mm x 3mm for the 3mm version readily found on Amazon or Ebay.

The 5mm magnet versions have a greater magnetic pull on the bits so better for larger bits.

You can also add a bit or two sideways on the exposed side of the magnet, so far I've just pushed the magnets into the body and it's been a good interference fit but you may need to glue yours.

I printed these using tough PLA at 0.2mm layer height and I printed them with the outside (closest to you in the photo) facing upwards with supports.