Ender 3 S1/S1 Plus/S1 Pro Twin Jet 5015 Fan Duct

I was originally using TX_Ryan's 5015 fan duct for the Ender 3 S1, but I recently switched to a larger heat block that causes the tip of the nozzle to be lower than the stock height.  As a result, I couldn't get TX_Ryan's fan duct to sit low enough to blow onto the part rather than the nozzle, even when adjusted to the lowest height.

I remixed the model to add additional adjustment so that it can be adjusted to sit lower.

Recommended print settings:

Material: PETG
Supports: Yes, use Snug or Grid, 0.2mm separation, 0 interface layers, support from build plate only.  You may want to use “paint on supports” to add a single support in the middle of the slot used for the mounting screws.  I have printed it without this support, but this only works if your settings are dialed in very well and you can successfully do a long bridge.
Nozzle: 0.4mm
Layer Height: 0.15mm or 0.2mm
Infill: 30%

Refer to TX_Ryan's model for additional information on the hardware (recommended fan model, bolts, and wiring).  https://www.printables.com/model/148897-ender-3-s1-twin-jet-5015-fan-duct