Barbed Wire - 1.6m coil & 0.8m straight segment

A set of two 3D models for printing fake barbed wire.

The coil measures ~168cm in total length, and prints 19cm wide so should fit on most machines.
An 84cm straight section is also included for belt printers. Both models are repeatable, so the ends of the sections line up for consistency.

If your file appears small in the slicer, try scaling up by 10%. They should print ~4.6mm tall

My TPU settings were as follows:

Hotend temp: 215°C
Bed temp: 60°C
Retraction: 3.5mm
Retraction speed: 25 mm/s
Layer height: 0.2mm
Infill: 25%
Speed: 30mm/s