Voron Trident-R1 MGN12H rear Z carrier

MGN12H rear Z carrier for Trident-R1

CHANGELOG

• 01.05.2023: WobbleX - Opened up the center hole (where the leadscrew goes through) too 13mm to allow for more leadscrew movement without interfering witht he carrier body.

• 25.04.2023: Variable pin sizes for WobbleX carriers, since it's been some issues with the pin sizes being either too small or large I've made a little test model so you can determine what suits you best. When you've found the right size for you then you choose the corresponding set of carriers.

• 15.04.2023: WobbleX v1.7, resized the pin holes too 2.9mm (the old/stock was 3.1mm and the pins would be loose and fall out).

• 15.04.2023: WobbleX v1.6, added recess for the WobbleX balls (missing in stock/MGN9H release too).

• 11.04.2023: Counterbore fix for all carriages & WobbleX v1.5.

• 11.04.2023: WobbleX v1.

• 30.11.2022: Initial release.

MGN12H rear Z carrier for Trident

Printing:

• Default voron settings, correct orientation, no supports needed!

Bom:

For "standard" carriers:

• Same as stock Trident except a MGN12H rail set.

For WobbleX carriers:

• 1x WobbleX WS8

• 1x MGN12H rail set

• Stock Voron Trident screws etc.

Description:

• Modifed Voron Triden r1 rear Z carrier to house a MGN12H block instead of MGN9H.

• One version for IGUS chains (2bolt), and one version for the generic Chinese ones (3bolt).

• Rail stop that's been sized to accommodate for a MGN12 rail.

• WobbleX implementation.

You will loose a tiny bit of Z travel, otherwise it's not much to "negative" (quite substantial loss of Z travel with WobbleX, but that's not isolated to this mod, it's just the nature of the beast).

Pictures:

WobleX version:

10.5mm(old) vs 13mm(new)

- - -

In case I forget to upload any eventual updates i make to the design to Printables, the latest released version should always be avalible on my gitub!