Second Life Palm Logo Earrings / Charm

Fun earrings that only those who know will enjoy!

Basically, paint the connecting part in the center clear in your slicer. Print very slow to keep the clarity of the clear connector, maybe even as low as 50mm per second.

Use auto generated tree supports for the connecting part, they will pop right off at this size.

Recommended .16mm layer height.

Recommend heating your eye hooks as inserting as shown. once you get a thread or 2 into the plastic it will begin to screw in. I should really make a jig or similar to make this part easy but you can do it by hand no problem.

There is a little wiggle room for scaling smaller but you want to insure thickness of the center connection point.