Voron Trident-R1 rear WobbleX carriers

Trident-R1 rear WobbleX carriers

CHANGELOG

• 01.05.2023: Opened up the center hole (where the leadscrew goes through) too 13mm to allow for more leadscrew movement without interfering witht he carrier body.

• 26.04.2023: Initial release.

Printing:

• Default voron settings, correct orientation, no supports needed!

Bom:

• 1x WobbleX WS8

• Stock Voron Trident screws etc.

Description:

• Since it's been a couple issues with the stock rear WobbleX Z carrier, which i have fixed for my MGN12H version i figured i could apply the same fixes to the MGN9H so that it's out there for those who need it. So here you go, enjoy!

• It's also been some issues with the pin sizes being either too small or large I've made a little test model so you can determine what suits you best. When you've found the right size for you then you choose the corresponding set of carriers & TR8 adapters.

10.5mm(old) vs 13mm(new)

- - -

In case I forget to upload any eventual updates i make to the design to Printables, the latest released version should always be avalible on my gitub!