May 5, 2023
Description
I wanted a tiny cable tie anchor and could only find 1" ones here and people were suggesting to scale it for 0.75" adhesive tape, but it also scaled the hole for the cable tie making it unusable.
Three files, all the same height, all allow 4mm cable ties
Small: 0.5" pad
Med: 0.75" pad
Large: 1" pad
No support needed, bridges print fine on Prusa. See below for Bambu settings to bridge better. I think concentric Top Layer makes for a good look.
If using Bambu:
(I tested this before the 1.6.2.4 update which was supposed to fix Archane issues with bridges)
- Slow down Speed: Bridge: 20
- Increase Advanced: Infill/Wall overlap: 60%
Amazon Cable Ties:
https://a.co/d/27Hqk2p
License:
Creative Commons — Public Domain
9
amzoo
