Kossel/Delta LED strip light

A LED strip holder for Kossel printer (but may be adapted to other).

The provided STL file are design for my Kossel XL 2020 printer (a Renren 3D Pro, really good chinese printer by the way).

It can be used to add 2 x 30cm LED strip (8mm width). Each strip holder came in two parts, the base and the extension, allowing it to be print on any 20cmx20cm common size printer.

A connector box is also included, that can contains a micro switch, and a bunch of connectors (up to 5 Molex KK254 for example). All these components can be solder in a simple piece of perfboard. On connector received the power, that pass through the switch, and then go to the other connector, Other connectors can be used to power multiple led strips.

I added the OpenScad source file, to the parts can be adapted to any printer. I use the most variable as possible at the begnining of the .scad, that should allow you to change every aspect (lenght, with, angle, profile size, led strip size...).

If you use to make LED strip holder for a specific type or printer, do not hesitate do create a remix with the printer in reference please, for other peoples :).

Print Settings

Printer Brand:

RepRap

Printer:

Rafts:

No

Supports:

Resolution:

0.2

Infill:

Notes:

Support (everywhere, not only bed based) are needed for the strips. Print them as is in the STL file, which means the side that will be on the profile at the bottom (on the bed).

The connector box is easy to print, no support need. Just print the switch face on the bottom (you need to rotate the provided STL file by 90°).

Category: 3D Printer Accessories