December 10, 2024
Description
Always have a flame on hand and ⋐Stick⋑ it anywhere! There are two versions of each design; one with magnets & one with magnets and a key ring loop.
I used a pair of flat, rectangular magnets in each Bic lighter case to maintain an ultra slim profile while also providing enough strength to hold securely to metal surfaces. You'll barely even know they're there! The magnet dimensions are 20 x 8 x 1.5 mm, and I purchased a fifty pack for fifteen dollars.
Pause during printing and insert two magnets. Make sure to turn one so they are attracted to each other rather than repelling.
Remove the label on the lighter with a blow dryer or heat gun to make it easier to insert and so that the label won't get shredded while inserting it into the case.
The fit is very snug so that the lighter will not fall out. There is a hole in the bottom to help remove the lighter when it's time to change it out.
Please note: This fits a standard Bic lighter without a plastic, shrink wrap design.
You might be interested in my other Bic Lighter Case designs!
Layers: 0.2mm
Walls: 3-4
Infill: 5%
Z seam: I have the best result with aligning it to the right or the back right
Speed: slow it down to make the outer surface clean and reduce ringing on the pattern edges
Need a quick print to test your first layer?
Are you interested in selling your prints of my designs? Join my Printables Club, and start making 💰 with your idle printers!
License:
Standard Digital File License
Grandpa 3DPrints
