Honeycomb Fan remix for Turing Pi v2

I needed a lid with a smaller hole, so I whipped this up in OpenSCAD.

The default fits a Noctua 40mm fan (https://amzn.to/3M0krLx) over top of a Turing Pi v2 board.

Everything is adjustable in Configurator using OpenSCAD. The overall size matches the Mochi case, but that can be changed in the editor. I did no refinement, basically everything is just sharp edges and inefficient pathways but it printed fine.

Material: PETG but it doesn't matter much

Settings: It is basically just a featureless square, so the only thing that matters is your top/bottom layer depending on which you want to be the visible side. Make sure the fan grate is at least 2 lines wide though ('thick' value should be around 1.5-2x nozzle width).