CR-10 V3 Hot End Cable Chain

I had some cable chains from a prior project that I wanted to use; therefore, using ideas from similar solutions I created this solution for your consideration.

The Hot End mount is in two parts held together by two M3-12 screws. I used 17 links between the mounts. I have included all the stl files for this solution.

1. The CR-10 V3 Control Base Chain Mount (male) is attached to the base near the control board. It is held in place by friction and a Nylon Cable Zip Tie.
2. The Chain link 16 allows you to print 16 links at one time.
3. The Clip 32 allows you to print 32 clips for the chain link to hold the cable in the channel of the link. One is needed per link.
4. The CR-10 V3 Hot End Base is held in place by friction. Two versions are provided, one has the means to hold the bl-touch cable away from the extruder gear, and the other does not.

Use "CR-10_V3_Hot_End_Base" if you are using BL-Touch

Use "CR-10_V3_Hot_End_Base_2" if you are not using BL-Touch 5. The CR-10 V3 Hot End Cable Mount (female) is the connection point for the cable chain link. The link with clip is a single unit.

Print Settings

Printer Brand:

Creality

Printer: 

Ender 5

Rafts:

No

Supports: 

No

Resolution:

200

Infill: 

40

Filament: inland PLA+ black

If you would like to buy me a cup of coffee.

Category: 3D Printer Parts