Better hair catcher for Easy Drain Aqua Plus Quattro MSI

I designed the filter part so that the natural vortex of the water wraps the long hairs around it. This way less of them should enter the drain itself. Because more hairs are catched this way, you'll need to empty this upper filter more often than the original one but you'll spend less time cleaning the entire drain, which isn't a nice job.

If you do have to clean the entire drain, this should be easier too. The original drain has a clamping mechanism which could make opening it quite messy. This one uses a thread and has a fully open design after opening it. 

Instructions

1. No supports needed
2. Don't print this in PLA. PETG works better with water. 
3. You'll also need 4x 10*2mm magnets.
4. Use the o-ring of the original drain on this one.