Dharma Wheel Coaster + Holder

So i tried printing coasters as a housewarming gift for my aunt and her husband, but i wasnt satisfied with the results on existing ones i tried (base too thin, walls too thin which causes holes in the PETG on top, no border on the coaster itself to aid in glasses not getting knocked over as easily, etc).

My aunt is really into eastern things like Buddhism and Hinduism, but also new age things. So i drew a Dharma wheel symbol as the floor of the coaster and left a 1mm edge above it to avoid things getting knocked over as easily.

The holder will hold up to 6 coasters inside it, you could probably fit another 2 by the lip but it wouldnt be very secure.

Dimensions: 90x5 mm for the coaster, 100.24x93.4x43.94 mm for the holder.

Print Settings

Printer Brand:

Creality

Printer: 

CR10S PRO

Rafts:

No

Supports: 

No

Resolution:

0.2

Infill: 

100% (do 999 top layers for simplicity)

Filament: AddNorth PETG Glitz Grey

Notes:

May have to do some heat smoothing with a butane torch (and to remove any smaller wisps) and cutting away leftover material on the knobs of the wheel if using PETG (Which i highly recommend if you intend to wash these, especially in a dishwasher. Make sure you use a low heat program as anything over 75-80 degrees will soften the plastic!).

Category: Decor