Lack V2 enclosure door gasket

The door of the Lack V2 enclosure has the largest gap and lowers the maximum chamber temperature.  This easy to use gasket will seal the gap and helps reduce noise as well.

This should be printed in TPU.  You do not need to use glue, the gasket should fit snug enough to stay on with just friction.  I suggest printing one gasket at a time, this will reduce stringing.

I am using the pocket door and there are ears on the gasket to accommodate this.  If you do not need these just print the middle gasket at the appropriate lengths. 

You will most likely need to update the values in the freecad file to meet your doors measurement.    One suggestion is to change the length to a small value and just print out a short section to use as a test fixture.  The included stls are for a total door height of 510mm.

The key values in freecad are: 

Length - length of the the top/bottom gaskets

FlatLength - length of the ears on the top/bottom gaskets

MiddleLength - length of the middle gasket.

NoGasket:

With Gasket: