Voron 2.4 Carbon Gantry Z Cable Mount

Mounts for the Chaoticlab CF gantry on the 2.4 (And probably trident) to route your wires using a standard tape measure covered in cable wrap.

There are 4 M3 heat inserts on the back of the inner bottom bracket, and two on the face, two on the side of the inner A  bracket.

Take a tape measure and cut off the correct length depending on your printer, scissors normally work for this. Round off the edges. Slide it through cable wrap, I used MDPC-X Big cable wrap, with two layers as you could see the bright yellow from the tape through it. Run all your wires through the concave side of the tape, heat shrink both ends.

Attach the inner A motor mount with 3x M3x10 BHCS to the CNC CF gantry mount with the tape and cables facing up, convex side of the tape facing the mount. Place the outer part over and screw in the two front screws (I used M3x14 SHCS) and then the two sliding screws on the side (M3x8 SHCS) and tighten them all down equally.

You will need to drill a hole wide enough for your cables into your deck with its center 10mm from the inner edge of your rear rail.

Put a single M3 roll in T Nut into the outside of the bed rail, and two on the top slot of the bottom  rear rail, then place the inner and outer bottom parts around the bottom of the cable. Screw the 4 retaining screws (M3x8 SHCS) to attach the two sides, then use a M3x16 SHCS through the third hole on the left side to attach to the bed rail, and two M3x8 SHCS to attach to the rear bottom rail.

Print settings

Standard voron part settings

40% gyroid

0.4 nozzle

0.2 layer height

4 walls

5 top/bottom