Gaggiuino 2.4, 2.8, 3.5, and 4.3 inch Nextion Display Housings

Fork of project site:

Open-Espresso/gaggiuino-builders: A Gaggia Classic control project using microcontrollers. (github.com)

Discuss:

Gaggiuino Builders | Facebook

You can buy these printed here at www.matter-replicator.com

For use with Nextion display on Gaggia Classic Pro. Run the wires through the steamer hole. Use two 60x10x3mm magnets.

PLA is ok for the normal ones, but higher-temp material is best for the 4.3"


Get a build kit here: Build kit for V3 PCB – Matter-Replicator

Get a PCB here: V3 PCB – Matter-Replicator
 

The Gaggiuino© logo and name is © Zer0-bit. I am not affiliated with the creators of the project.
 
Note: The 3.5 inch LCD file was created by Steve Nofs

Note: This display is upside down from the normal build so that the wire can be near the steamer hole, so you will need to use the Nextion Editor to change the display to 270 degrees.


FINDMAG 6 Pack Powerful Neodymium Bar Magnets Rare Earth Magnet Bar, Strong Bar Magnets Neodymium Magnets with Double Sided Adhesive - 60 x 10 x 3 mm: Amazon.com: Industrial & Scientific

 The 4.3 inch one also can use these magnets at the top, which seem important for stainless models:

https://www.amazon.com/gp/product/B0BTSWCCXG/ref=ppx_yo_dt_b_asin_title_o00_s00?ie=UTF8&psc=1