EBB36 CAN Bus Board Stepper Motor Mounting Bracket - With Mini Buck Converter Holder

This is a Mounting Bracket design for the EBB36 CAN Bus Board, with an option for an integrated bracket for a mini Buck Converter PCB.  The mounting holes for the main bracket (that are used to secure the EBB36 to the back of the extruder) are oriented for the Vz-Hextrudort extruder.  This design was created for use with the Mantis XOL 2 toolhead, but will probably work with most toolhead designs that use the Vz-Hextrudort extruder, or any other extruder with the same hole orientation.  This design is also configured to us a PG7 gland that clamps in at the top.  The main EBB36 mounting bracket contains 4 rectangular holes, 2 on each side, for zip ties to secure wires.

I used this mini buck converter, however, I think most of the mini buck converters all have the same footprint.

Printing Parts:

• I printed the main bracket with the opening facing up.  In other words, the area where the EBB36 mounts would be facing up.
• The small buck converter bracket orientation should be obvious.  I printed mine with the large flat area facing the build plate.
• The back half of the PG7 gland clamp, should be printed with the semi-circle opening facing up.