Foot acupressure mats

Here's a version of strshp's acupressure mat designed specifically for your feet.

The tops of the spikes are flat with a diameter of approx. 0.8mm to make it easily printable but still pointy enough for the spikey feel!

I recommend printing the mats with 0.2mm layer height with 0 top and 0 bottom layers but therefore 60% infill for the first two layers and then 0% infill for the spikes. This makes the mats nice and flexible, so if you feel like it, you can cut them and use them as insoles in your shoes. How cool is that?! Since the spikes are pretty small there is no additional infill needed besides the two perimeters.

For each foot, two pieces are printed. Simply connect them with some adhesive tape.

Printing information

Layer height: 0.20mm
Infill: 0-0.4mm = 60%; 0.6-3.4mm = 0%
Support: none

I am looking forward to your Makes! :-)

If you like this design, feel free to check out my others here.

And maybe you would like to support me with a small donation. Feel free to use the support button on the top right of this page. I myself donate one or two Euros to each designer for an interesting model that is worth five stars to me.

The following filament was used in the pictures above:

• Extrudr PLA Neon Orange