55 Geometric Ring Holders - Vase Mode Compatible

A large collection of Geometric Ring Holders that are designed to be printed upside down in vase mode.

The Ring Holders have the following specifications.
Height: 120mm
Bottom Diameter: ~35mm
Top Diameter: ~5mm

Feel free to modify the variables in the Source CAD to make it whatever size you require. The shapes are also available for you to modify and tweak to your requirement.

Made with Onshape:
Source CAD: Ring Holders

Print Recommendations:
The main challenge with this print is adhesion and cooling at the very start. Change your settings as needed to reduce blobbing.

I highly recommend adding a tiny dot of glue stick to your bed, even if you don't normally need it, where the model meets the bed. After printing, you can always remove the glue with warm water and some paper towel.

Turn the model upside down, small point at the bottom, so it can be printed in vase mode.

Enable Vase Mode
0.2mm Layer Height
Set extrusion width to 2x the nozzle size (no need to go above 0.8mm if you have a big nozzle)
Enable the cooling fan for the first layer, or the tip could become a blobby mess.
Initial Layer line Width to 100%

Profiles:

All profiles have variations that either merge gradually into a circle or into the same profile.

Profiles also come in twisted variations.

The simple shape profiles also come in rounded variations.