Support hanger for MK3 Powersupply

If you make an enclosure for your i3 MK3 you should move the powersupply outside the box to allow sufficent cooling.
On the bottom of the PS there are two slots for screws but the top wobbles around, not anymore with this simple hanger.

Print instructions

print with robust material,
I used 0.4mm nozzle

If you need the measurements for the wood:

Plywood (Siebdruckplatte) 18mm
2pcs 596536mm (top and bottom)
2pcs 560450mm (left/right)
1pcs 536450mm (back)
1pcs 554449mm (door)
for the door I used this standard hinges for furniture doors, the doorpanel is 18mm to wide so it stands over on one side and can be used as a handle.

inner dimensions LxWxH:
560x500x450mm

I put a slot with 300mm in the top to feed the filament through (with a router) and made a small gap in the rear panel for the cables.
Next to the filament-slot I placed a 24V LED strip which is powered by the PRUSA powersupply.