Z endstop support adjustable (reprapdiscount)

Adjustable Z support for the mechanical endstop from reprapdiscount.com.

The clamp diameter is for a 10 mm stub.

It is inspired from oTTo's support http://www.thingiverse.com/thing:16458

2020/09/03: Revision 3 is just a little bit more accurate and made with Freecad, the previous one was made with SketchUp.

Print Settings

Printer:

CR-10 V3

Supports:

Resolution:

0.2

Infill:

Notes:

No raft needed but a brim may be used for better adhesion.

Instructions

The supports need to be removed to leave the room for the pins soldered crossing the circuit board.

The raft can be peeled off, sometime a drill bit is needed for the hole.

BOM:

2 x M3x30 screws

2 x M3 nuts

1 x Spring (mine is 7x15 mm from paoparts.com)

Category: 3D Printer Parts