Laptop Stand for 180 Degree Open Laptops When Working with Separate Keyboard and Mouse

I have a System 76 laptop that opens 180 degrees.  I needed a laptop stand that would get the keyboard out of the way and raise the monitor to eye level.  I have a ASUS ROG Strix 17.3" and Kinesis keyboard and Logitech mouse as my diginal nomad setup.  This stand is indispensible for when I am on the move. 

The stand is sturdy so there is no worry the laptop will topple over ( make sure the table is sturdy and leveled though ).  

The design assumes you will not need your laptop's keyboard.  The laptop bottom thickness up to 15mm.

Tested on a System76 Pangolin laptop.

I printed 15% infill.

There is 0.1 mm tolerance for where the part come together.

The crossbar will print in a 220mm by 220mm area if you rotate and print vertically, it is 30cm

You need to print two pillars and one crossbar.