June 15, 2023
Description
A way to use a drill for rewinding a roll of Filament for any reason that may happen. Using a half inch bolt and a power drill.
Material needed
Two of the winders3
½ inch bolt, I used one thats about 4 inches long
½ inch nut
½ inch washer x2
Drill
On the bolt it should go washer spool holder empty spool holder washer nut. Tighten the nut as much as possible. That is just a matter of feeding him and through the bottom hole and slowly spinning directing the filament so it's distributed evenly
License:
Creative Commons — Attribution — Noncommercial — Share Alike
7
VG Prints
