Clamp wall, Parametric

3D printed parametric wall clamp for pipe, Default diameter 32mm

Manufacturing procedure:

• Material: PETG (possible alternatives ABS, ASA, PC, PA11), not recommended PLA
• 3D Printer: FDM 3D printer, average print time 30 – 60 minutes, depending on parameters
• Slicer settings: 4 perimeters, 0.2mm layer height, print in the position where the clamp is lying on the print bed to increase the strength and adhesion to the print bed
• Post processing instructions: Clean the stringing, check clearance of the screw
• Assembly instructions: Use the screw (default diameter 4mm) to mount to the wall, insert pipe

Following parameters can be adjusted using Autodesk Fusion 360:

• PipeParameter - Enter value from 20mm to 40mm, for higher or lower values the right geometry might not be generated.
• ClampThickness - Enter value from 12mm above
• Clamping Angle - Enter value from 60 to 150 degrees.
• ScrewDiameter – Enter value according to the used screw with 0.1-0.3mm more for tolerance
• ScrewHeadDiameter – Enter value according to the used screw with 0.5- 1mm more for tolerance
• DistanceFromWall - Distance of Pipe diameter from the wall