Design Trophy

Design trophy figure for the top of a trophy. Great to recognize outstanding student designs.

Print instructions

Design trophy figure for the top of a trophy. Great to recognize outstanding student designs. I used this as an example for a student project on incorporating fasteners into a 3D printed part. The students all made their own trophy figures with similar captured nuts.

Trophy figure stands 90mm (3.5 inches) tall. Works great with a wooden base or could be used to replace a figure on the top of another trophy.

Notes:

Rotate +280 degrees (or -80 degrees) about X axis to lay the back surface flat on the bed as shown in the screenshots. Prints well with no supports.

Post-Printing

Spray paint all over, brush the details and clearcoat the finished part.

Assemble with a 1/4-20 nut in the slot and a 1/4-20 machine screw through a base.

You can add sections of PVC or wood with a 5/16 hole through it to make the trophy taller.

Or use standard trophy parts.

The fasteners are sized to fit standard 1/4-20 trophy threaded rod and couplings. If you want to use this to replace the top of another trophy it works great.