Phone stand - Loopy case and Popsocket compatible

Desktop phone stand fits a variety of devices and cases. Compatible with Loopy cases and with Popsockets or other fixtures attached to the back.

Print instructions

Prints clean with no supports required. Model will come into the slicer already oriented on it's side. 0.3mm layer thickness works fine.

Recessed holes included on the bottom for optional grip pads. To add grip pads using hot glue:

1) put a piece of aluminum foil or wax paper on a smooth, flat surface (like a marble counter top)
2) turn the print upside down
3) put equally sized drops of hot glue in each recessed hole, approximately twice the depth of the hole
4) set the stand on the foil or wax paper and let the glue cure
5) a couple of popsicle sticks or coins are useful to hold the base level while the glue is curing
6) peel the foil or paper off the glue pads and use your new stand

Hope you find it useful.

Gcode file is set up for Atomic Filament PETG.

Original work, modeled in Autodesk Fusion 360