Vase with Ridges Inside

Can your printer handle this vase in vase mode? This is definitely an experimental design (There may be some weird lines when viewing the model, but it prints perfectly fine 😉👌). This model will also work nicely with two or three perimeters as a normal print.

This model is small, so you can experiment with scaling too! When using vase mode I increase the outer wall thickness to somewhere between 0.6mm and 0.8mm. This helps close the gaps where there are steep angles in the vase. Just be sure to check the preview in your slicer before printing!

Are you interested in selling your prints of my designs? Join my Printables Club, and start making 💰 with your idle printers!