General purpose ESP32-WROVER Web Cam module Mount - mod with ventilation holes and gopro mount

Notice
This enclosure is still quite small to host other modules with it, unless you remove pins and solder directly to the dev board.

About:

Modification of General purpose ESP32-WROVER Web Cam module Mount.
- extra holes for air ventilation on the side of the antenna
- flat top (no insets for screws) to allow gluing other parts such as GoPro mount, also no insets allows to add other small electronics for example temperature/humidity sensor such as AHT20 or BMP280
- GoPro mount with 1mm 20x20mm base, to be manually glued to the back or front (depending on the use case).

Please give a like and post makes and provide comments for further improvements.

Print:

PETG 0.2mm, models are small enough that print without supports is possible.