**UPDATES** 6/29/2023
- I fixed the path that the m3 square nut/ hex nut slides into to mount the Mini-SB to the mount
I had created a custom mount for the Mini-Stealthburner toolhead for my heavily modded Ender 3 v2. When I decided to covert it over to a Voron Switchwire, I designed a mount for the MS that would be compatible with the Switchwire system. This specific model has an integrated CR Touch slot as well.
Disclamer
I hope that people find this helpful, I simply created this for my own needs. I have tested this mount on my own printer and seems to be working great, but that doesn't mean that it's guaranteed to work on your setup. I am by no means a 3D modeling pro and still learning!
Hopefully someone can take inspiration from this to create an even better one!
Insights:
- No modifications needed to Mini-Stealthburner housing, basically plug and play
- I printed all these prints in ASA with a .12 Fine setting in BambuStudio Slicer on my P1P
- I used 100% infill just to ensure that they are solid pieces, I'm sure you could probably get away using a smaller infill.
- Mount it to the linear rail before inserting the M3 square nuts
- I also used the M3 5mm x 4mm heat set inserts in the “X bearing block”
- I sliced the "X bearing block in half so that the CR touch cable can run through the center without issue. It doesn't loose any integrity for the mount.
- You can also use the inductive probe if you wish that's mentioned in the official Switchwire BOM
- I have been using the Haldis Red Lizard K1 hot end on my MS (Phateus Dragon dupe), so the CR touch is about 1mm above the hot end, which is perfect for my setup.
- Compatible with MGN12H linear rails
- In the photos, I used heat set inserts instead of M3 square nuts, don't recommend.
BOM:
- 4 M3 5mm x 4mm heat set inserts
- 2 M3 hex nuts
- 2 M3 thin square nuts
- 1 Microswitch
- 2 M2x10 Self-Tapping screws
- 2 M3x16 SHCS
- 2 M3x40 SHCS
- 4 M3x8 SHCS
- 4 M3x12 SHCS
- 2 M3x30 SHCS for mounting MS to the mount
Future iterations:
- Maybe create a way to attach the bottom of the MS to the mount for added stability
Shoutout to @prasadp4009 for the integrated CR Touch mount for the Voron Stealthburner
Shoutout to @Thefahmialias_227890 for the “X Carriage” mount design for the Voron Mini-Stealthburner for the Ender 3 v2
TinkerMAN
