June 27, 2023
Description
I wanted to replace a 4010 hot end fan on a Mini-Satsana fan duct with a 5015 to eliminate hot end creep when printing lower temperature materials on an Ender 3 with all metal hot end. The slant was to allow continued use of the BL-Touch mount that used the bottom two screws on the 4010 fan. It also directs air flow down the length of the hot end heat sink.
The mount is 5mm thick, so in my case that will alter the probe mount offset by 5mm closer to the nozzle.
The blower output should fit down into the mount opening.
License:
Creative Commons — Attribution — Noncommercial — Share Alike
7
Nikdfish
