Edge Header Programmer Clip Via Probes (e.g. OpenLog Clone) (Customisable)

Edge Header Programmer Clip Via Probes (e.g. OpenLog Clone)
Author: Brian Khuu 2019

This is originally designed for connecting to OpenLog Clones

I used P100-E2 probes for this

Note: The purple openlog clone Programmer Port essentally has [GND, RST, SCK, M0, MI, Vin]

FYI if programming openlog connect above to

AVR ISP

[MISO(1)][VTG(2)] [SCK(3)][MOSI(4)] [/RES(5)][GND(6)] [MOSI(1)][VTG(2)] [NC(3)][GND(4)] [/RES(5)][GND(6)] [SCK(7)][GND(8)] [MISO(9)][GND(10)] Note: I've also included an experiment, where I included a side grip version. Haven't tested it in practice besides a few test prints, but you can let me know if it works. The nice thing about the experimental version, is it should be easier to use and also adapt to other board types

Print instructions

Category: Electronics Summary

Edge Header Programmer Clip Via Probes (e.g. OpenLog Clone)
Author: Brian Khuu 2019

This is originally designed for connecting to OpenLog Clones

I used P100-E2 probes for this

Note: The purple openlog clone Programmer Port essentally has [GND, RST, SCK, M0, MI, Vin]

FYI if programming openlog connect above to

AVR ISP

[MISO(1)][VTG(2)] [SCK(3)][MOSI(4)] [/RES(5)][GND(6)] [MOSI(1)][VTG(2)] [NC(3)][GND(4)] [/RES(5)][GND(6)] [SCK(7)][GND(8)] [MISO(9)][GND(10)] Note: I've also included an experiment, where I included a side grip version. Haven't tested it in practice besides a few test prints, but you can let me know if it works. The nice thing about the experimental version, is it should be easier to use and also adapt to other board types