LED Holder for Pirahna Super-Flux RGB LEDs and Williams/Bally Pop Bumper Bodies

LED Holder for Pirahna Super-Flux RGB LEDs and Williams/Bally Pop Bumper Bodies

Created by Outpost Kodelia (https://www.thingiverse.com/OutpostKodelia)

License: Creative Commons - Attribution

This is designed to fit in the standard Williams/Bally pop bumper body and mount

a Pirahna Super-flux RGB LED bulb. It uses stock screws/holes to mount and to

run the wires through to the bottom of the playfield.

Install the bulb on the side with the triangle mark. Align the corner notch on the

LED with the triangle. On the back side, solder wires perpendicular to the

terminals according to the labels. Then route the wires through the neighboring

holes* so they are now coming out the top of the adapter. Remove your old light

and the screws that hold the bumper down. Now run the wires down through the

body's wire holes. Snug the wires up and screw it down with the original screws**,

aligning the countersunk screw holes with the original screw holes. Wire up to

your controller and enjoy!

• Some pop bumper bodies may not have the raised rings around the wire holes. If

yours don't have the raised rings, you can route the wires directly from the

soldered pins down into the body's wire holes. Pictures for both are attached.

** Depending on your original screw length, you may need to use screws that are

up to 1/8" (or 4mm) longer to account for the extra height.

Recommend using 26ga wire to ensure all four wires fit through the two wire holes.

Should also work with any other RGB LED with 5mm square pin spacing.

v0.1 - Initial creation.

Print recommendations:

• Supports: No
• Reduce speed to improve accuracy and reduce strings around small details
• Print at high resolution

This should work with the following Williams/Bally parts:

• 03-7443-5
• 3A-7443
• Wico 19-0155
• 545-5199-00

Print Settings

Printer Brand:

Prusa

Printer:

Rafts:

No

Supports:

Resolution:

0.05 mm

Notes:

Category: Video Games