November 22, 2023
Description
Remix of the HSW Dymo 160/280 Holder. Mount to hold the Dymo label maker on your Honeycomb Storage Wall.
I have been using the original version of this for a few months but found that it stretched over time and made the grip loose, to the point where I was afraid the label maker might fall off the wall. So I made a simple modification to add a bar across the front to help reinforce it. This holds the label maker a bit tighter and should prevent it from stretching in the future.
2023-11-22 Update: I added a Wide version of this. The width is increased by a few mm just to allow easier insertion of the label maker. It also lets it sit a bit lower, freeing up some space above it on your honeycomb wall. Added a picture of both.
Printer: AnkerMake M5
Filament: PLA+
Infill: 20% Gyroid
Perimeters: 3
Solid Layers: 5 top, 4 bottom
Supports: No supports required
Layer Height: 0.2mm
License:
Creative Commons — Attribution — Noncommercial — Share Alike
Steve
