Skadis Back Mount for Ikea Bror System

This mount allow the mount of the Skadis panel on the back of a Bror System. It works with M3 inserts.

I have seen others systems but I was after a design that is mostly hidden behind the panel.

It prints well without supports at .2 mm layer height. It is recommended to be done in PETG, but PLA works great also.

For a single mounting point it is needed:

• 2x M3 Screw (any from 10mm to 16mm).
• 2x M3 Washer.
• 2x M3 Thread Insert. I used a 8mm long one.
• 1x Bror Interface printed part (Left or Right).
• 1x Washer printed part (Esthetics).