Uppababy Vista Cup Holder

I remodeled and made some changes to an existing design for an UppaBaby Vista stroller cup holder. 
I provide 3d files with the design as well as the stl for both part: the cup holder and the clip. 

please note that I didn't had the chance to try and print it to see if it fits. 
I'll be doing so in the next couple day. 

the cup holder is design to fit a medium starbucks coffee. 
I'll be updating with further size of cup holder when I need and design the different sizes. 

I would print the cup holder upside down (opneing for the cup) on the bed as I think it would require less support and be the strongest as the jonction of the cup and the part where it slides onto the clip. 

As for the clip, I would print it with the ‘’prong'' thouching the bed too. 

Also, I'll be printing this in either abs, asa or petg of heat resistance has my stroller is very often sitting in the car. 


08/2023 - A medium starbucks cup fits in, but doesnt quite touch the bottom of the cup holder. A couple mm bigger in diameter would allow the bottom of the cup to sit at the bottom of the cup holder. 

09/2024 - Please, do some test before going out with your bottle in the holder. The holder isnt very high and I wouldnt recommend to use a ‘’high'' bottle. My rule of thumb is that the portion that is in the holder should always be in greater proportion than what is outside the holder. 
I say it again, it was design to fit a medium starbucks coffee/drinks. 

If you have request for a specific bottle, please let me know and I'll do everything I can to accomodate you.