NR200 PSU Cover

I made this cover to tie everything together in my build. And it hides the wires around the PSU.

The RGB strips are Phanteks Neon strips and they must be cut to length.

The 55cm one (M5) should reach all the way around but I suggest you get more than you need just in case you make a mistake.

Peel the rubber caps of the ends to reveal the LED strip inside. Can be soldered.

PRINT IN HIGH TEMP PLASTIC, such as PETG. PLA will warp over time inside the PC.

Can be printed in both orientations, use supports either way.

You won't be able to fit the connector through the wire hole, so you need to either remove the pins from the connector so you can fish the wire through, or crimp on a new connector like I did.

The cover is made to be a press fit over the stock PSU cover, but you might need to sand it a little inside, or if it's too loose, you can make up the difference with short strips of something like painters tape.

Print Settings

Printer Brand:

Creality

Printer:

Rafts:

No

Supports:

Resolution:

0.1000

Infill:

Filament: 3DE Premium PETG

Category: Computer