August 15, 2023
Description
Cyberpunk 2077 is an open-world, action-adventure story set in Night City, a megalopolis obsessed with power, glamour and body modification. You play as V, a mercenary outlaw going after a one-of-a-kind implant that is the key to immortality.
RELEASE DATE:
19 Nov, 2020
Inspired by s199's Cyberpunk 2077 logo.
Photoshop was used to make the 2D images.
Converted to SVG and imported into 3D software.
Layer Height: 0.2mm
Plastic type: PLA (Black & white)
Nozzle Size: 0.4mm
The LED strips are secured with hot glue.
I used 10mm wide LED strips and just cut them along the sides to
make it fit better in the narrow parts of the print.
High density ws2812b LED strip that can be cut between each LED
(Get: 60leds/m IP30)
But i found a 4mm wide equivalent
(Get: 4mm 3535 60leds or 5mm 5050 Black 60leds)
I think it's the better choice, but mine is still in the mail from china.
So i just went with what i had.
Alternatively you could just scale the print up.
But it barely fits on a 300x300 print surface as it is now.
To connect the strips together, i highly suggest you get some small diameter wire
with silicone insulation that doesn't melt when you solder.
(Get: Red, Green and White)
I used this kind of wire to run the wire into my computer.
(Rip off the blue wire)
I then used this kind of connector to connect that wire to the end of the LED strip in the computer.
You might need a different kind of connector depending of what device you are connecting it to.
The print can be wall mounted with some double sided tape, So the stand is optional.
But if you end up using the stand it can be super glued to the back of the shell.
License:
Creative Commons — Attribution — Share Alike
DROUGA
