Generic Beitian BN-880 mount to zip-tie it on top of uav

About

I had a look around, and I didn't really find a solution that i liked much, so I designed my own.

there is two channels for small zip-ties in the bottom, and its angled about 20 degrees to the back, so a forward flying drone should have it face upward.

I've test printed it in PET-G and final-printed it in TPU, both variants held my BN-880 just fine (i had to cut it out of the PET-G one, so i could put it in the TPU one.

If this is useful to you, please leave a make-picture :)

Printing it

I've been printing it on the side with tree supports. TPU is recommended.

Category: R/C Vehicles