LTT Screwdriver Case Bit Holder (8x3mm magnet PressFIT)

This is a modification of the LTT Screwdriver Case Bit Holder (8x3mm magnet version) from https://www.printables.com/model/372998-ltt-screwdriver-case.

I found that with my Voron 2.4 using a klicky probe (which has strong magnets for attaching/detaching the probe) the original model had no way to keep the magnets in place, so the probe base would grab all the magnets and jam my toolhead.

I modified the model to to clean up some modelling issues and place 7 evenly spaced 3x8mm magnets in the base.

I find pausing the model at layer 19 or 20 is best, but check with your slicer depending on your print settings.  I use my thumb to press the magnets in, but you could use a soft tool to help press them in if needed (ie.. your tolerances are not perfect…. I recommend this tool https://www.printables.com/model/46099-thwack)

I'm also currently working on adding a remix/modification of the base from the original model due to the original magnet holes being too big and improperly spaced (makes it very difficult to install the magnets into the base holder (black piece in my picture)