Eibos Cyclopes Filament Dryer handle - single finger

The Eibos Cyclopes Filament Dryer does not have a handle and it bugged me a lot that they didn't design something like this.

*The holes are slightly smaller for drilling/sizing on your own**

• You will need a small bit or an M4 tap bit to make the hole a little wider. Here is a link for a great metric tap set…

https://www.amazon.com/gp/product/B0861QXJ6Z

-The holes are 10mm deep in the handle.

• Uses (2) M4 x 12mm button cap screws.

Eibos Cyclopes Filament Dryer....

https://www.amazon.com/Official%E3%80%913D-Filament-Adjustable-Temperature-Compatible/dp/B0BFQXHRV5

Print Settings

Printer Brand:

TEVO

Printer: 

Tornado

Rafts:

No

Supports: 

No

Resolution:

.25mm

Infill: 

30%-100%

Filament: Matterhackers PETG Orange

Notes:

I did something like 30%, 4 top and bottom layers, 3-4 walls.

You can do 100% if you want. I don't think it matters that much.

Post-Printing

Tap set does help. You could also use a drill bit sized for just under M4, then drive the M4 into the handle from inside the lid.

Category: 3D Printer Accessories