HSW Cable Organizer

Loved the design and print of the KLIPPT and adapted it for my under-desk HSW solution.

Print Instructions: 

The compliant hinge will work best with PETG, but ABS, ASA or even PLA will work as well but may break if open/close-cycled too often. This model is optimized to be printed with a 0.4 mm nozzle using the Arachne slicing Engine. Please dial in your filament to ensure proper fitment.

Install Instructions:

Klippt Parallel: has end-stops on one side (identified in beginning of gif), identify the side with the smaller nibs. Open the latch and compress/flex/bend the bottom part by applying force, so that the middle section becomes straight. Then slide the hook onto the KLIPPT from the side with the smaller nibs.

Klippt Perpendicular: Flex the clip as described above, insert one side of the hook perpendicular to the opening.

HSW Installation: The hook attachment has a arrow designed onto it. Insert that side onto the HSW first AT AN ANGLE and push to snap into place. Similar to the gif below.