Amazon Echo Pop Outlet Stand

Amazon Echo Pop Outlet Stand. It's been a few months and still 0 STLs out there for this item so I did my best to get us something. The charging brick and cable route into the back of the stand and then the stand itself plugs directly into the outlet. Tight tolerances are required for this print in order for the charging brick to fit snugly and not fall down once plugged in. If you print it and it's loose you can use some folded paper to tighten the fit or if you print it and it's too tight there are little circular “nubs” inside you can break off with a screwdriver to slightly widen the fit. For my print it fit perfectly as is. Print will function with infill as low as 10% but you may see the infill through the walls. So add some walls/perimeters or up the infill. Very little support is needed, tree supports work well. Stand is large enough where the Echo can be tilted left or right as shown in the picture. Feel free to remix or improve on it as I'm not very creative. Let me know if the model worked out for you!