2.5-inch SATA Drive Quick-swap Holder for 2020 Extrusion

I bought an 2020 extrusion open case. Now I want a way to hold my SATA SSDs so that I can quickly and easily swap them. So here's a solution that you can print within 2 hours.

Compatible with 100x70x7mm 2.5" SATA drives.

First, purchase a right-angle SATA adapter. I bought mine from Amazon. Make sure the two holes on the adapter are of the same 3mm size. If you want easier insertion/removal of the drive, cut the 3 tabs on the inside of the female side of the SATA connector flush with a razor blade.

You will also need TWO sets of M3x16mm hex screws and nuts. [Link]

Print the L and R parts and attach them to the adapter with the screw and nuts, and then you can slide the assembly into the extrusion.

[Printing]

Print the parts with the flat side facing down. Turn off support.